# Klipper with Artillery X1

**URL:** http://forum.3dprintbeginner.com/t/klipper-with-artillery-x1/1775
**Category:** Artillery 3D
**Created:** [November 10, 2023, 11:02am UTC](http://forum.3dprintbeginner.com/t/klipper-with-artillery-x1/1775 "2023-11-10T11:02:56Z")
**Posts on this page:** 2
**Page:** 1

<div class="post-metadata">

### Author: ![Mirva](http://forum.3dprintbeginner.com/letter_avatar_proxy/v4/letter/m/aeb1de/32.png) [@Mirva](http://forum.3dprintbeginner.com/u/Mirva)
#### Post date: [November 10, 2023, 11:02am UTC](http://forum.3dprintbeginner.com/t/klipper-with-artillery-x1/1775/1 "2023-11-10T11:02:56Z")

</div>

A question that I don’t know if it has been asked before. Is it possible to install Klipper on an early Artillery X1?  
I have it with the modified firmware (from 3Dprinter beginner 🥰)so that it uses the Z sensor as a level sensor and PEI base, and the original board, although I have a BIGTREETECH SKR V1.4 Turbo BTT SKR 3 board in a box, without installing​:see\_no\_evil:. Is it possible to update it? I need to install first the 24bit SKR1.4 board? Will the Creality Sonic Pad a good solution? What do you recommend?

---

<div class="post-metadata">

### Author: ![floriano](http://forum.3dprintbeginner.com/letter_avatar_proxy/v4/letter/f/67e7ee/32.png) [@floriano](http://forum.3dprintbeginner.com/u/floriano)
#### Post date: [March 8, 2024, 12:45am UTC](http://forum.3dprintbeginner.com/t/klipper-with-artillery-x1/1775/2 "2024-03-08T00:45:57Z")

</div>

Hello… this post if from Nov 23

I just did this on my Artillery X1 - using BTT-CB1 board,  
my Artillery was STOCK …

Some hiccups… but it works ( I did smoke the extruder heater block right away… waiting on replacement)

I can elaborate on what I’ve done… if you are still wanting to run Klipper.

Let me know…