# So i am a newbe to 3d printing,could use some help

**URL:** http://forum.3dprintbeginner.com/t/so-i-am-a-newbe-to-3d-printing-could-use-some-help/2080
**Category:** Artillery 3D
**Created:** [April 12, 2024, 8:00pm UTC](http://forum.3dprintbeginner.com/t/so-i-am-a-newbe-to-3d-printing-could-use-some-help/2080 "2024-04-12T20:00:10Z")
**Posts on this page:** 1
**Page:** 1

<div class="post-metadata">

### Author: ![blwn71](http://forum.3dprintbeginner.com/letter_avatar_proxy/v4/letter/b/8e7dd6/32.png) [@blwn71](http://forum.3dprintbeginner.com/u/blwn71)
#### Post date: [April 12, 2024, 8:00pm UTC](http://forum.3dprintbeginner.com/t/so-i-am-a-newbe-to-3d-printing-could-use-some-help/2080/1 "2024-04-12T20:00:10Z")

</div>

got my printer ,was trying to get it set up ,ran through the small amount of filliment they sent and started on a fresh roll of pla.problem one every time i started a print with what was on sd card,they would never print right and would break loose from print deck.so i releveled the bed about a dozen times ,did the auto leveling,then tried to update software.now i have a huge problem,my printer wont do crap now,i dont know if i messed up the firmware or what but it will start the upload process on the little screen and stops at 8 percent.my screen dont even have english words on it anymore,its all in chineese i believe.when i tap on the tools or settings the box will show up but it doesnt take me to solection.have i toasted my printer?  
just in case i have i just ordered a creality ender 3 max neo becuase it has a bigger print surface.