# Sonic Pad + Vyper

**URL:** <http://forum.3dprintbeginner.com/t/sonic-pad-vyper/1626>\
**Category:** Ask for help\
**Created:** [September 8, 2023, 2:42am UTC](http://forum.3dprintbeginner.com/t/sonic-pad-vyper/1626 "2023-09-08T02:42:46Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![CeeKay](http://forum.3dprintbeginner.com/letter_avatar_proxy/v4/letter/c/439d5e/32.png) [@CeeKay](http://forum.3dprintbeginner.com/u/CeeKay)\
**Post date:** [September 8, 2023, 2:42am UTC](http://forum.3dprintbeginner.com/t/sonic-pad-vyper/1626/1 "2023-09-08T02:42:47Z")

</div>

I have a Vyper and have see online that a few people are using the Sonic Pad to control it with. I’ve followed the guiode in Ricky Impey’s video on configuring the Vyper and the Sonic Pad, but when I go through the calibration steps after installation, I get a “No trigger on probe after full movement” messages for calibration and Z-axis movement?

Any ideas on what may be the problem?

Thanks

---

<div class="post-metadata">

**Author:** ![badghost](http://forum.3dprintbeginner.com/user_avatar/forum.3dprintbeginner.com/badghost/32/1035_2.png) [@badghost](http://forum.3dprintbeginner.com/u/badghost)\
**Post date:** [August 24, 2024, 12:36am UTC](http://forum.3dprintbeginner.com/t/sonic-pad-vyper/1626/2 "2024-08-24T00:36:55Z")

</div>

Have you done the manual bed levelling prior to auto bed levelling, if you go back to Rickys amazing video guides 9 times out of 10 you have either a missed a command or setting (Trust me I have been their setting up two Sonic Pads)
