AnyCubic I3 Mega Prints Fail

Ask for help
1
  • 3D Printer Model: AnyCubic I3 Mega
  • Slicer: Cura 5.7.2
  • Hardware Setup: Controlled by OctoPrint via USB
  • Problem description:

Benchies
Benchies1920×1440 260 KB

  • What I tried: Initially, I used a custom model, which failed in the same way. I checked All3DP to see if they had any troubleshooting guides. None of theirs matched my issue. I tried printing a Benchy to see if it was an issue with model, but that had the same problem. Any advice would be appreciated!
2

Partial clog / Wet filament.

Dissasemble the hotend. Inspect nozzle / heatbreak.

Check filament dryness.