- 3D Printer Model: Ender 3
- Slicer: Ultimaker Cura or Creality
- Hardware Setup:
- Problem description: Cannot get the “Y” setting to move forward, have lost about 25 - 30 mm in bed travel. The bed at Auto Home goes too far back and the extruded Nobel is out in front of the bed by th same distanace 25-30 mm
- What I tried: Ger Err - Too Far when moving the Y Steps/mm from 80 to 85
Need help in resetting the “Y” to Normal so prints go to the center of the build plate and their entire build plate is accessible to print on .