- 3D Printer Model: PROFORGE 3 makertech
- Slicer: cura
- Hardware Setup: not sure
- Problem description: trying to calibrate running the ubl and the printer with dual extruder will go off bed causing the probe to crash as the fix sensor is out of the canvas
- What I tried: I have tried several tweaks at firmware level and nothing has worked. Since I am
Not able to connect to the slicer ( I think is related to the board installed , I might required the communication board )
I don’t know wha else to do, at least from the control panel on the printer I don’t seem to have other options to tweak settings
The board on the printer is an BTT SKR2
I have attached a picture any thoughts are appreciated
