Originally published at: Ender 3 S1 Plus Review | 3D Print Beginner
The Ender 3 S1 Plus is, just like the name implies, a bigger variant of the Ender 3 S1 printer I recently reviewed. It has a larger printing volume of 300x300x300mm while also bringing the touchscreen from the Ender 3 S1 Pro. In this article, we’ll go over the specs…
Great article about this printer. I just received mine yesterday and it works reasonably well. However, I am noticing that the autoleveling is not performing as well as it should in my opinion. I did a test print that covers most of the plate and am seeing that it prints a little too close on the right front side and a little too high on the back left side. Have you run a similar test? I had this exact problem on my old Ender-3 Pro even after I installed a BL-Touch. I finally replaced the controller board (I have a V1) and that resolved the issue for it.