A question that I don’t know if it has been asked before. Is it possible to install Klipper on an early Artillery X1?
I have it with the modified firmware (from 3Dprinter beginner 
)so that it uses the Z sensor as a level sensor and PEI base, and the original board, although I have a BIGTREETECH SKR V1.4 Turbo BTT SKR 3 board in a box, without installing:see_no_evil:. Is it possible to update it? I need to install first the 24bit SKR1.4 board? Will the Creality Sonic Pad a good solution? What do you recommend?
Hello… this post if from Nov 23
I just did this on my Artillery X1 - using BTT-CB1 board,
my Artillery was STOCK …
Some hiccups… but it works ( I did smoke the extruder heater block right away… waiting on replacement)
I can elaborate on what I’ve done… if you are still wanting to run Klipper.
Let me know…