Originally published at: https://3dprintbeginner.com/voron-trident-fysetc-kit-review/
That’s right! I built a VORON. FYSETC sent me their VORON Trident 350 Kit to review, and in this article, we’ll go into detail to learn more about how good this kit is, and what was my experience putting it together. Before we start, I need to share a bit…
1 Like
I’m having trouble even getting PETG to extrude. It jams up quickly. What fan did you use to replace the hotend fan?
I used this one if I remember correctly: https://s.click.aliexpress.com/e/_DCG1Cz1
It’s a Sunon 24V 4010
This one should also work well: https://s.click.aliexpress.com/e/_DEuTgWT
Hmm. I haven’t tried a that particular fan. I bought another on Amazon but it doesn’t seem to puch much more air. I even printed a shroud to push the air over the heartbreak more directly. I’m having major clogging issues with all materials including ABS. It will run for 20 minutes or so and then it heat soaks and clogs.
You need a fan that generates a lot of airflow, and some Amazon fans are not that great.